Водный охладитель для процессора Thermaltake RL240

Pacific PT40-D5 Reservoir/Pump Combo
The PT40-D5 includes a 220mm reservoir and D5 pump to provide the perfect combination for proper water cooling circulation and capacity, manufactured from high quality POM and PMMA material.

Pacific RL240 Radiator
With high-density fin design (FPI: 14), the 240mm radiator is optimized to accommodate high airflow and high air pressure with increased capacity and provides superior cooling performance to all components.

Pacific 1/2” ID x 3/4” OD Compression Fittings (Chrome)
Six durable brass compression fittings allow proper connection to G1/4” ports to properly secure to cooling components.

Luna 12 LED Red Fan
An efficient and quiet cooling LED fan with anti-vibration mounting system, which strengthens the stability during operation.

V-Tubler 4T
The V-Tubler 200cm ID 1/2” (13mm) water tube provides custom PC water cooling configurations with flexibility and durability from end to end.

Coolant 1000 Red
Eco-friendly pre-mixed red coolant for custom PC water cooling configurations; prevent corrosion, rust and scaling across every component for a total system solution.

Remarkable Expansion
The Pacific RL240 water cooling kit provides multiple DIY components for users to build the ultimate in custom configuration, allowing enthusiast to build up aesthetically-superior water cooling systems by incorporating externally-modular upgrades for their chassis.

Caution

• Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks
• To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
• Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
• It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
• Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

• Thermaltake recommends the following steps to be taken after completing your water loop setup
• It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
• Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
• DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
• Fill the reservoir to the top as it will prevent air from going into the pump
• If necessary tilt the system slightly from side to side to bleed the air out of the loop.
• Place some paper towels under fittings and joining points to test for leaks.
• Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
• Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
• Coolant might fade over time.